* Overdrive and Compression on two separate channels with individual tone controls.
* Overdrive channel sounds like the original TS808 and even uses the JRC4558 op-amp.
* Unique overdrive bass boost switch.
* Compression channel can be set for fully squashed "Nashville" sound or very subtle compression.
* Compressor also has an integrated pre-amp controlled by a Gain knob so you can get loads of clean gain without overdrive!
* Combine the channels to heat up leads.
Route 66 American Overdrive is sure to become as legendary as its namesake. With classic compression combined with classic overdrive modeled after the sound of the original TS-808 Tubescreamer (JRC4558 chip and all!), the Route 66 pedal gives you two great effects for the price of one. The two effects sound great on their own and can also be combined to compliment one another. In fact, probably the only complaints about the original Tubescreamer was that it did not have much sustain or bottom end. That won't be a problem with Route 66. Just combine the overdrive side with the compression side to get all the sustain you want. Add the Overdrive Bass Boost and give it that big cabinet sound. If you love the clean sound of your guitar and amp, but just want a clean boost, kick in the compressor with the Gain knob up a bit. We've added a pre-amp stage to the compressor to allow for a truckload of gain, with or without overdrive. Using Route 66 American Overdrive with a good tube amp is sure to make it sing! Classic.
List Price $169
Our Price $129.95
MULTI-PLUG 5 CABLE,
* The ONLY daisy-chain available with right-angle plugs!
* Over 12" between plugs!
* Spring-loaded contacts in the input socket keep the 1 SPOT plugged in securely.
* Link Multi-Plug 5 cables together to power even more effects!
Our Price $9.95
NW-1
• 9V adapter takes up only one spot on a power strip or wall outlet but powers multiple pedals!
• 1000mA max rating powers multiple pedals (analog pedals typically draw 10-20mA each, digital 50-80mA, Line 6 approx. 350mA. Check rating with manufacturer).
• Accessory cables/converters (see below) allow the 1 SPOT to work with virtually any 9V pedal... even Line 6* modeling pedals!
• Works with any equipment that uses one of the following adapters*: Boss PSA, Boss ACA, Danelectro DA-1, DOD PS-200R, Dunlop ECB-03, Ibanez AC-109, Korg A30950, Morley 9V, Zoom AD-0006.
• Will run on domestic or international voltage (100-240V), no transformer is needed.
• Shielded for low noise, and 10 foot cable is almost twice as long as other adapter cable.
List Price $24.95 Our Price $19.95
This page was last updated: November 12, 2009
Visual Sound H2O Liquid Chorus and Echo
The H2O Liquid Chorus & Echo continues the Visual Sound tradition of combining two professional quality effects into one reasonably priced pedal. First, you get liquid analog chorus created by using the new Visual Sound BBD ("bucket brigade") chips. With controls for Speed, Width, and Delay Time, you can get an endless variety of chorus sounds from subtle to lush to under water. Then there's the echo channel. Up to 800ms of analog voiced, digital echo. You can switch from short to long echo times on the fly and dial in just the right settings with the familiar controls: Echo Time, Repeats, and Effect Level.
The H2O even has a second output jack for sending a dry (uneffected) signal to a second amp. And if you prefer to have an effected signal going to your second amp, the pedal can be easily modified to accomodate that.
Like other Visual Sound pedals, you can use either channel by itself or combine them together. Just stomp on both switches at the same time to switch from one channel to the other or to turn them both on or both off.
List Price $199 Our Price $169.95
Converters $2.99 Each
CL-6 Converter
for the 1 SPOT
Allows the 1 SPOT adapter and Multi-Plug 5 cable to be used with Line 6* modeling pedals and the Digitech RP100.
• Right-angle plug is ideal for crowded pedal-boards!
C-35 3.5mm Converter
for the 1 SPOT
Allows the 1 SPOT adapter and Multi-Plug 5 cable to be used with any 9VDC pedal with a 3.5mm (1/8") power jack.
• Right-angle plug is ideal for crowded pedal-boards!
C-YR Reverse Polarity Converter for Yamaha
for the 1 SPOT
• Allows the 1 SPOT and MC5 cable to power Yamaha keyboards, samplers, and drum machines, as well as certain reverse polarity effects pedals.
C-Bat Battery Clip Converter
Power anything that runs on a 9V battery
The CBAT Battery Clip Converter allows the 1 SPOT and MC5 cable to power anything that runs on a 9V battery.
1 Spot
MC-8 Multi-Plug 8 Cable for 1 SPOT
Power up to 8 effects with a single 1 SPOT adapter using this cable accessory.
The Visual Sound Multi=Plug 8 Cable is an accessory for the 1 SPOT 9V DC adapter. Takes up only one spot on a wall or strip outlet. The Multi-Plug has 8 right-angle plugs for daisy-chaining power, with over 12" between plugs. You can also link other Multi-Plugs together to power up even more effects or pedals. Multi-Plug uses spring-loaded contacts in the input socket to keep your 1 SPOT securely plugged in.
NOTE: The 1 SPOT cannot be used to power multiple LINE 6 ToneCore Pedals due to inadequate power supply filtering in the pedals. A 1S POT can be used with one ToneCore Pedal with only a minimal amount of noise. More than 1 ToneCore pedal on a daisy chain causes too much noise for practical use.
Visual Sound Multi-Plug 8 Cable for 1 SPOT Features:
A daisy-chain available with right-angle plugs
Over 12" between plugs
Spring-loaded contacts in the input socket keep the 1 SPOT plugged in securely
Link Multi-Plug 8 cables together to power even more effects
